Ghost Holster mod kit install manual




Install the part1 of spacer in to the holster.

If you want to adjust the spacer , please install the micro screw.

up to 1-5mm, use M3*10.

up to 6-12mm, use M3*15



Install the part 2 of spacer , install the last screw on other side.



Put some screw glue .



If you want to diy your logo later , please put a plastic in right place with wil contact

with the holster's spring.


If you will not diy your logo , you don't need to do this.



Copyright 2016 HONGKONG About Guns Modify CONTACT US.