Polymer Gen 3 RTF Frame installation manual
Open the package we will have a frame and 2 dummy pin ( Black) .
a1
We don’t install it for customer because we have pin sets sell separately , choose your favor colour and just install dummy one time .
Make sure the C corner is face outside . And put it in place .
Use a paper for pad . And install both side .
Some day if you want to change a colour , please follow this step to remove the dummy pin . Remove the right side dummy pin first then the left side .
We added material in the marked place for a more real under cut , so the mag catch have to do a little modification if you're using the steel / metal mag catch . ( Plastic mag catch just need a little bit push )
The yellow area need to cut a little bit
down if you're using the metal mag catch .
After this modification , it should be like this .
When install , push the spring to the right then install the mag catch as usual .
Another need to remind is we design a “fitting dot “ at the hammer housing place . It need to force to fit every frame . It’s better to hold the hammer housing , even you don’t install the rear screw , the hammer housing also hold tight .
At first you install the hammer housing is like this , you can see there is a gap and the rear pin hole in not in line .
But you only need is a push the fit . When you see the hole is in line and the gap disappear . It means it’s ready to assembly .
The holes are in line
The gap disappear
And then you will find out that you just install the rear pin and don’t need the rear screw , the hammer housing just still tight !!!
Enjoy the shooting !!!